So some basic understanding of the options described in this file is neccessary. If you should have any comments or suggestions, please contact: MS-DOS also provides the ability of multi-boot menues or multi configurations. It is included for compatibility with older applications. Flaming or offending other users Illegal activities: By using UMA, you free more space in conventional memory for programs. Click Start, Run , type regedit , and then press Enter.

Uploader: Tekinos
Date Added: 28 February 2007
File Size: 32.48 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 71232
Price: Free* [*Free Regsitration Required]

If you never have touched your autoexec. Win98 certainly does not need it. So disabling this option can speed up your disk system a bit. But be warned that smartdrive by default enables a write back technique. SYS with a value exceeding the default loaded by IO. So we want to order it at first. The second driver loaded should be EMM Programm output however is of course not disabled.

The following list shows each value and its associated base address in hexadecimal format: Click Start, Runtype syseditand then press Enter. By disabling this option you will get the command line at startup and can start windows easily by typing “win”.


How do you install EMM

Any memory not required is still available as extended memory for other programs. Delete some programs or buy a new hard disk. This post has been flagged and will be reviewed by our staff. It is included for compatibility with older applications. For instance, 64, is the maximum allowed Uses approximately 33,k of RAM. However insatll you have to use EMS you can insfall your config. To give the operating system access to both the upper memory area and expanded memory, use the ram switch.

Proffitt Forum moderator June 30, 1: If dos recognizes that the program would not fit into the umb area enm386 is loaded to conventional memory automatically, so you can not make any mistake when using this command. Reboot and see if the error goes away. If there is an error of any sort, post a reply to this thread with the exact error displayed. In my configuration all drivers are loading “high”.

Then you have to go to the command prompt, either with a shell in Windows or from boot disk, emm3886 which ever way you prefer. And we don’t need any of them. Device drivers are allocated 4 kilobytes one page of space to be used as a stack. The memory in between is normally not used by any cards you might have installed except perhaps some very old network cards.


In addition, when himem and emm – not loaded by default using either the ram or noems switchesare loaded specifically in the Config. But of course it is instal, system and protected, so at first we have to set some proper attributes: The addresses for pages 0 through 3 inxtall be contiguous in order to maintain compatibility with version 3.

I think the best would now be to explain those terms now. If you do not want 4dos, ignore this line now.

Error message “EMM386 not installed” during windows bootup

But some years later insstall was able to purchase graphic adapters that could display bitmapped graphics. Also, verify whether Himem. This will save you 64K of conventional memory.

The article [ Q ] lists most of the common entries that are incorporated into IO.